SmartCare Damp Block 2K is a two component acrylic polymer-modified cementitious high performance coating. This product can be used for both positive & negative side waterproofing due to its excellent bonding, good waterproofing and unmatched resistance to hydrostatic pressure.

SmartCare Damp Block 2K can be used for following interior areas: 

masonry surface: Brick walls/concrete slabs subjected to damage from moisture/efflorescence 

waterproofing of sunken areas: Bathrooms, toilets, swimming pools, balconies etc.

The SmartCare Damp Block 2K has a coverage of 7.5 - 8 square feet per kg for 2 coat.

The SmartCare Damp Block 2K is available in 3 kg and 15 kg packs.

There are a few precaution to be taken while applying Damp Block 2K:

1. For anti efflorescence coating cement plaster sould necessarily be removed from the affected areas up to the brick level.

2. Do not add water to SmartCare Damp Block 2K during mixing or application.

3. Always add powder to Liquid, not reverse, to ensure that the mixture is free of lumps.

4. The 7 days of curing (after screeding) is absolutely essential. 

5. Do not conduct ponding test before the applied product gets completely cured.

6. In case of fresh concreate or masonry substrate, the surfaace must be cured for 28 days before application.

7. Overlaying of cementitious screed or plaster must be done within 24 to 48 hours of application.

SmartCare Damp Block 2K is a two component product, one component is polymer liquid and another one is cementitious powder.

If properly closed, and kept away from frost and humidity, the shelf-life of SmartCare Damp Block 2K is 12 months.

The application procedure for SmartCare Damp Block 2K comprises 5 simple steps:

1. Remove old paint, putty or existing POP using a chisel and wire-brush. In case of efflorescence, cement plaster should be removed from the affected areas up till the brick level.

2. Add powder to liquid (2:1 ratio) slowly under stirring until get the homogenous slurry.  Keep the slury undisturbed for 5/6 minutes to release entrapped air during mixing.

3. Apply 2 coats of SmartCare Damp Block 2K slurry by brush or roller over masonry/brick surface. 1st & 2nd coat must be applied in crosswise direction.  Achieve a  coverage of 7.5 square feet per kg for the system.

4. In case the cement plaster is removed prior to the application, an overlay of cement plaster must be done within 24 to 48 hrs.

5. A gap of 4-6 hours should be given between coats.